Trimble Access v2016.03 released!

TA201601Trimble Access 2016.03 was released on August 15, 2016.

Note: TA 2016.02 was recently released – see previous blog article or click here for the release notes  to read about all the newly added features!

 

 

General Survey

New Features and Enhancements:

When you open a job in Trimble Access that does not have a defined project height, you are now
prompted to enter the project height in a dedicated Project height screen. Previously, the prompt
opened the Key in parameters screen, and you then had to click Projection and then navigate to
the last page to enter the Project height value.

Resolved issues in the 2016.03 recent release:

  • Points with attributes in a linked job
  • RTX points have no coordinates
  • S Series total station connectivity
  • M3 Disable compensator setting
  • Application Errors

Roads

Resolved issues:

  • Staking a GENIO road

Tunnels

Resolved issues:

  • Station points incorrectly calculated
  • Application errors

 

To install and run Trimble Access software version 2016.03, you must have a warranty agreement valid April 1, 2016.

Click here to see the complete release notes for this version

Users should update their TSC3 Operating System Firmware update

Due to Microsoft changes, it is recommended that you upgrade the TSC3 Operating system firmware to 3.0.3

3.0.3 can be found at the following webpage FIRWMARE UPDATE BE SURE TO BACKUP YOUR COLLECTOR as OS upgrade will erase all files on your collector.

Leave a Reply

Your email address will not be published. Required fields are marked *