Trimble Access v2016.11 released!

2016_11
Trimble Access v2016.11 was released on November 21, 2016.

There were a few important issues resolved from the v2016.10 release. Click here to see the complete Release notes for this version

General Survey

Resolved Issues

Incorrect station value for an alignment: An issue when the display delta option was set to Station and offset where the station value displayed in the navigation screen was always in Meters when the units specified for the job were either International feet or US survey feet is now resolved. This issue occurred when staking a:

  • Station on alignment
  • Side slope from alignment
  • Station/skew offset from alignment

Note that the station value displayed at the Confirm staked deltas screen and stored in the job was correct if you stored any information in 2016.10

Logging in
Feature codes
Application errors

Roads

Enhancements

Improved cross section view display when surveying a Trimble or LandXML road
When accessing the cross section view at the graphical selection screen, the displayed cross section is for the station at your current position. This applies when measuring your position relative to:

  • a selected string
  • the nearest string

Previously the displayed cross section was for the station where you tapped the screen to select the string.

Resolved Issues

Incorrect station value for a Trimble road

  • Measuring your position relative to the road
  • Measuring your position relative to a string
  • Staking a station on a string, when the display delta option was set to Station and offset

Note that the station value displayed at the Confirm staked deltas screen and stored in the job was correct.

Navigation arrow not pointing to the start of the string
Accessing the cross section when surveying a road
Application errors:

To install and run Trimble Access software version 2016.11, you must have a warranty agreement valid October 1, 2016 or later.

Click here to see the complete Release notes for this version


Users should update their TSC3 Operating System Firmware update

Due to Microsoft changes, it is recommended that you upgrade the TSC3 Operating system firmware to 3.0.3

3.0.3 can be found at the following webpage FIRWMARE UPDATE BE SURE TO BACKUP YOUR COLLECTOR as OS upgrade will erase all files on your collector.

Leave a Reply

Your email address will not be published. Required fields are marked *